EdgeStar BIDW18BL -1, Owner'S Manual

Page: 30 / 34

EdgeStar 18” Built-In Dishwasher
26
Troubleshooting
Follow the troubleshooting guide below to resolve common
issues.
Issue Possible Cause Solution
Dishwasher does not
start Fuse is blown or
circuit breaker is
tripped Replace fuse or reset circuit
breaker. Remove any other
appliances sharing the same
circuit with the dishwasher.
Power Supply is
not turned on Ensure the dishwasher is
turned on and the door is
closed securely.
If applicable, make sure the
power cord is properly
plugged into the wall socket.
Dishwasher door
is not properly
closed Close dishwasher, ensuring
that the door latches.
Water not pumped
from dishwater Kink in drain hose Check drain hose
Filter clogged
Check coarse filter
Improper
detergent Use only the specified
detergent. If improper
detergent was used, open
the dishwasher allowing suds
to evaporate. Add 1 gal. of
cold water to the tub. Close
and latch the door. Start the
“Rinse” wash cycle to drain
the water. Repeat if
necessary.
Suds in tub Spilled rinse aid Always clean up rinse aid
spills immediately.
Detergent used
contained
colorant Do not use detergents with
colorants.
Stained tub interior Hard water
minerals While wearing rubber gloves,
use a damp sponge to
clean the interior with
dishwasher detergent. Never
use any other cleaner to
clean dishwasher.
White film on
dishwasher interior
surface Items are not
non-corrosive. Do not place non-
dishwasher safe items in
dishwasher.