Edge XTREME EDX1800.2FD-EO, User Manual

Page: 6 / 28

1. Low level input
For connection to any source (head unit) with a low level output. This is your RCA output from the
source (headunit)
2. High Pass Filter (HPF)
This control is used to set the HPF crossover frequency for the amplifier. The frequency is adjustable
between 15Hz and 1kHz.
3. Low Pass Filter (LPF)
This control is used to set the LPF crossover frequency for the amplifier. The frequency is adjustable
between 50Hz and 15kHz.
4. Gain control
This control is used to match the input signal of the source to the amplifier. See the setup section
for more details.
5. Bass boost control
This control is used to add bass boost to the amplifier centered at 45Hz and is adjustable between
0dB and +12dB.
6. Remote input socket
Used to connect the remote level control to the amplifier.
7. Power / clip / protect LED
If the amplifier is operating normally, the GREEN LED will illuminate.
If the amplifier output is clipping, the YELLOW LED will illuminate.
If the amplifier is in protection mode the RED LED will illuminate.
8. Speaker terminals
Used to connect speaker cables to the amplifier. See the wiring configuration section for more details.
9. Power terminals
Used to connect DC power to the amplifier. See the power connections section for more details
1 2 4 6 7 8 9
3 5
6 EDX1800.2FD
Terminals And Connections