Edge PresencePlus P4, User Manual

Page: 59 / 182

01/05
P/N 120413
51
User’s Manual Tools Screen
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Adding and Removing Tools
To add a tool:
The following steps provide an overview for setting up Vision tools in an inspection. Steps not available for some of the Location
or Analysis tools are noted.
1. Click the button of the tool to be added to the inspection.
2. Rename the tool.
For more information, see Renaming Tools on page 51.
3. Draw the ROI (not available for Analysis tools).
For more information, see Region of Interest (ROI) on page 52.
4. Set Input options to indicate the expected results (not available for the Test tool).
For more information, see Examples of Logic Results (in Section 7, Tools ) on page 93.
5. Add a Test tool.
6. Configure the Test tool inputs and, if desired, configure the desired results.
See Test Tool Overview (in Section 7, Tools ) on page 59.
7. Set the judgment parameters in one of three ways:
- Use Quick Teach.
- Use Teach.
- Manually set the judgment parameters.
To remove a tool:
1. Choose the tool to be removed in the Navigation/Results window.
2. Click the
Delete button in the lower-left corner of the screen.
Renaming Tools
The default name of each tool can be edited or replaced (examples: LOCATE_1, TT_2). Each name must be unique.
To edit the tool name, click on the Name field (double-click to select the entire name), and type to change or replace the name.
•
Enter up to 49 characters; only alphanumeric characters and underscores (no spaces) are valid.
•
The button in the Navigation/Results window that appears will show the first nine characters after exiting the tool.
----------------------------------------------
Delete Buttons