Edge PresencePlus P4, User Manual

Page: 138 / 182

130
P/N 120413
01/05
Run PresencePLUS ® P4 EDGE
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Run Results
Name Level Parent Level Description
Current Inspection First None Name of current running inspection.
The Camera Second Inspection
Name
Sensor Information:
-
Gain; see
Setting Exposure and Gain
(in
Section 5, Setup
)
on page 40.
- Exposure time (ms).
The Trigger Second Inspection
Name
Trigger Input Information (see the following referenced subsections
in
Section 5, Setup
):
- Divide: See
Trigger Divide (range: 1 – 10,000 triggers)
on page 46.
- Delay: See
Trigger Delay (range: 0 – 8,000 ms)
on page 46.
- Width: See
Minimum Trigger Width (range: 1 – 8,000 ms)
on page 46.
- Polarity: See
Polarity
on page 44.
The Inspection
Manager
Second Inspection
Name
General inspection information:
- Fail hold time (ms):
how long a failed image is displayed on the monitor
- Power-up time:
time since last shutdown (resolution = second)
- Pass count
- Fail count
- Missed trigger count:
total number of triggers missed because Sensor was not Ready
- Lifetime:
how long the Sensor has been turned on (resolution = 1 hour)
- Total inspection time minimum (ms):
minimum inspection time recorded (resolution = 0.1 ms)
- Total inspection time maximum (ms):
maximum inspection time recorded (resolution = 0.1 ms)
- Total inspection time (ms)*:
inspection time from trigger until end of processing time for last
inspection (resolution = 0.1 ms) (does not include inspection capture
to PC
*
)
- Config timestamp:
when inspection was created
* Capturing an image on the PC adds to the inspection time. Set
display settings to
None
to decrease the inspection time to a
minimum.
Tools
(tool name)
Second Inspection
Name
Information about current tool:
- Execution time
(resolution = 0.1 ms)
- Inputs (parameters set for the current tool)
- Results (results of the current tool)
System Log First None Not used