Edge DBX Series, Manual

Page: 8 / 20

8
Amplifier Strapping
Two Identical EDGE EDA monoblock amplifiers are capable of being strapped together to deliver the
combined output of both amplifiers into a single channel.
NOTE: only identical amplifiers may be strapped together.
Strapping procedure
· Connect the RCA input from the source unit to the left and right RCA input of the master amplifier.
· Connect a mono RCA lead between the Bridged socket of the master amplifier and the slave amplifier.
· Set the input mode switch of the master amplifier to Master.
· Set the input mode switch of the slave amplifier to Slave.
· Connect speaker cable between the Positive speaker output of the master amp and the Positive
speaker output of the slave amplifier. The cable must be of the same gauge you will be using to
connect the amplifiers to the subwoofer.
· The master Negative speaker output is to be connected to the subwoofer positive terminal.
· The slave Negative speaker output is to be connected to the subwoofer negative terminal.
Set the mode select switch
to Master.
Set the mode select switch
to Slave .
Minimum impedance 2Ω