Edge-Core ES4524M-PoE, Management Manual, Page: 343 / 560

SNMP Commands
4-73
4
snmp-server user
This command adds a user to an SNMP group, restricting the user to a specific
SNMP Read and a Write View. Use the
no form to remove a user from an SNMP
group.
Syntax
snmp-server user username groupname [ remote ip-address ] { v1 | v2c | v3
[ encrypted ] [ auth { md5 | sha } auth-password [ priv des56 priv-password ]]
no snmp-server user username { v1 | v2c | v3 | remote }
• username - Name of user connecting to the SNMP agent.
(Range: 1-32 characters)
• groupname - Name of an SNMP group to which the user is assigned.
(Range: 1-32 characters)
• remote - Specifies an SNMP engine on a remote device.
• ip-address - The Internet address of the remote device.
• v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
• encrypted - Accepts the password as encrypted input.
• auth - Uses SNMPv3 with authentication.
• md5 | sha - Uses MD5 or SHA authentication.
• auth-password - Authentication password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted password.
(A minimum of eight characters is required.)
• priv des56 - Uses SNMPv3 with 56-bit DES data encryption.
• priv-password - Privacy password. Enter as plain text if the encrypted
option is not used. Otherwise, enter an encrypted password.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The SNMP engine ID is used to compute the authentication/privacy digests
from the password. You should therefore configure the engine ID with the
snmp-server engine-id command before using this configuration command.
readview The associated read view.
writeview The associated write view.
notifyview The associated notify view.
storage-type The storage type for this entry.
Row Status The row status of this entry.
Table 4-24 show snmp group - display description (Continued)
Field Description