Edge-Core ES4524M-PoE, Management Manual, Page: 337 / 560

SNMP Commands
4-67
4
Command Usage
• If you do not enter an snmp-server enable traps command, no notifications
controlled by this command are sent. In order to configure this device to send
SNMP notifications, you must enter at least one
snmp-server enable traps
command. If you enter the command with no keywords, both authentication
and link-up-down notifications are enabled. If you enter the command with a
keyword, only the notification type related to that keyword is enabled.
• The snmp-server enable traps command is used in conjunction with the
snmp-server host command. Use the snmp-server host command to
specify which host or hosts receive SNMP notifications. In order to send
notifications, you must configure at least one
snmp-server host command.
• The authentication, link-up, and link-down traps are legacy notifications, and
therefore when used for SNMP Version 3 hosts, they must be enabled in
conjunction with the corresponding entries in the Notify View assigned by the
snmp-server group command (page 4-71).
Example
Related Commands
snmp-server host (4-64)
snmp-server engine-id
This command configures an identification string for the SNMPv3 engine. Use the
no form to restore the default.
Syntax
snmp-server engine-id { local | remote { ip-address }} engineid-string
no snmp-server engine-id { local | remote { address }}
• local - Specifies the SNMP engine on this switch.
• remote - Specifies an SNMP engine on a remote device.
• ip-address - The Internet address of the remote device.
• engineid-string - String identifying the engine ID. Range: 1-26 hexadecimal
characters)
Default Setting
A unique engine ID is automatically generated by the switch based on its MAC
address.
Command Mode
Global Configuration
Console(config)#snmp-server enable traps link-up-down
Console(config)#