Edge-Core ES3510MA-DC, Management Manual, Page: 794 / 1098

C
HAPTER
33
| Spanning Tree Commands
– 794 –
which cover the same general area of your network. However,
remember that you must configure all bridges within the same MSTI
Region ( page 794 ) with the same set of instances, and the same
instance (on each bridge) with the same set of VLANs. Also, note that
RSTP treats each MSTI region as a single node, connecting all regions
to the Common Spanning Tree.
E
XAMPLE
Console(config-mstp)#mst 1 vlan 2-5
Console(config-mstp)#
name
This command configures the name for the multiple spanning tree region in
which this switch is located. Use the no form to clear the name.
S
YNTAX
name name
name - Name of the spanning tree.
D
EFAULT
S
ETTING
Switch’s MAC address
C
OMMAND
M
ODE
MST Configuration
C
OMMAND
U
SAGE
The MST region name and revision number ( page 794 ) are used to
designate a unique MST region. A bridge (i.e., spanning-tree compliant
device such as this switch) can only belong to one MST region. And all
bridges in the same region must be configured with the same MST
instances.
E
XAMPLE
Console(config-mstp)#name R&D
Console(config-mstp)#
R
ELATED
C
OMMANDS
revision (794)
revision
This command configures the revision number for this multiple spanning
tree configuration of this switch. Use the no form to restore the default.
S
YNTAX
revision number
number - Revision number of the spanning tree. (Range: 0-65535)