Edge-Core ES3510MA-DC, Management Manual, Page: 715 / 1098

C
HAPTER
26
| Access Control Lists
ARP ACLs
– 715 –
ARP ACL
S
The commands in this section configure ACLs based on the IP or MAC
address contained in ARP request and reply messages. To configure ARP
ACLs, first create an access list containing the required permit or deny
rules, and then bind the access list to one or more VLANs using the ip arp
inspection vlan command ( page 691 ).
access-list arp
This command adds an ARP access list and enters ARP ACL configuration
mode. Use the no form to remove the specified ACL.
S
YNTAX
[ no ] access-list arp acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
When you create a new ACL or enter configuration mode for an existing
ACL, use the permit or deny command to add new rules to the bottom
of the list. To create an ACL, you must add at least one rule to the list.
◆
To remove a rule, use the no permit or no deny command followed by
the exact text of a previously configured rule.
◆
An ACL can contain up to 128 rules.
E
XAMPLE
Console(config)#access-list arp factory
Console(config-arp-acl)#
R
ELATED
C
OMMANDS
permit, deny (716)
show arp access-list (717)
Table 88: ARP ACL Commands
Command Function Mode
access-list arp Creates a ARP ACL and enters configuration mode GC
permit, deny Filters packets matching a specified source or
destination address in ARP messages
ARP-ACL
show arp access-list Displays the rules for configured ARP ACLs PE