Edge-Core AS5700-54X, Cli Reference Manual, Page: 142 / 1116

Chapter 4
| System Management Commands
Line
– 142 –
Line
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
line
This command identifies a specific line for configuration, and to process
subsequent line configuration commands.
Syntax
line { console | vty }
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Table 20: Line Commands
Command Function Mode
line Identifies a specific line for configuration and starts the line
configuration mode GC
databits *
Sets the number of data bits per character that are
interpreted and generated by hardware LC
exec-timeout Sets the interval that the command interpreter waits until
user input is detected LC
login Enables password checking at login LC
parity *
Defines the generation of a parity bit LC
password Specifies a password on a line LC
password-thresh Sets the password intrusion threshold, which limits the
number of failed logon attempts LC
silent-time *
* These commands only apply to the serial port.
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the
password-
thresh command
LC
speed
* Sets the terminal baud rate LC
stopbits * Sets the number of the stop bits transmitted per byte LC
timeout login response Sets the interval that the system waits for a login attempt LC
disconnect Terminates a line connection PE
terminal Configures terminal settings, including escape-character,
line length, terminal type, and width PE
show line Displays a terminal line's parameters NE, PE