Control Panel
Instructions
Please check to make sure all parts are intact before use.
1. Press the on/off switch on the base of the unit. The unit will be
in stand-by mode.
2. Touch the POWER button on the top of the unit or on the
remote control and you will hear a click. The unit will turn on
in high heat mode. The indicator light will be red. Touch the
POWER button again to turn the unit off. It will continue to
run for several seconds to purge the warm air out of it.
3. After turning the unit on, you can change modes by touching
the “MODE” button on the remote. The modes are High Heat,
Low Heat and Fan.
Introduction
The EdenPURE
®
GEN40 comes equipped with easy, touch button
operation on the unit, as well as a remote control. It puts out a lot
of air, while running quietly. It has a tip-over switch, which shuts
the unit off if it were to tip over. The GEN40 can be set to oscil-
late to provide heating/cooling over a wide area. It has a carrying
handle at the top, so it is portable and can be moved from room to
room.
The GEN40 uses a PTC thermal unit, which heats up quickly but
does not have an open flame, so it is suitable for home and office
use.
Specifications
Name: GEN40
Rated voltage: 120V
Model: A5956
Rated Power: 1500W
Electric shock class: II
Rated frequency: 60Hz
Handle
Remote
Control
Dust
Screen
Remote
Control
Place
Indicator
light
Light red light - High heat
Dark red light - Low heat
Blue light - Fan
No light - Off
Turnplate
Base
PTC
Plug
On/Off
1
2
