background image

EdenPURE

®

 360 Super Climater

®

EASY START UP GUIDE

 

1.   Make sure the master switch on the back of the unit above the plug is in the “I” position.

 2.  When you plug in the Climater, you will hear one beep and see a red light next to the power button 
    indicating the unit is getting power.
 3.  Press the 

power button

 to turn the Climater on or use your remote control to turn the Climater on.

 4.  Mode Key Functions:

     

a. Press the mode key one time to get to HH (Heat High). You can adjust your temperature with 

      the 

arrow keys

 above the 

mode button

. The temperature will then display.

     

b.  Press the 

mode key

 two times to go to HL (Heat Low). You can adjust your temperature with 

      the 

arrow keys

 above the 

mode button

. The temperature will then display.

     

c.  Press the 

mode key

 another two times to go to F1-9 (fan mode). You can adjust the fan speed to levels 

     

  1 through 9 with the 

arrow keys

 above the 

mode button

.

Cooling Mode Wind Noise

The high-tech impeller fan runs very quiet. It has 10 speeds. The higher noise levels you hear at the high 
speeds are not due to the fan but to wind velocity. This is unavoidable if you want high wind chill cooling. 
A ceiling fan at top speed only produces a wind velocity right under the fan at floor level of about 300 ft. per 
minute. This only produces -7.3° wind chill. When you get out from under the fan, the wind velocity drops 
dramatically. The Super Climater Fan produces a wind velocity near the unit of 600 ft. per minute at a top 
speed which produces -14.7° wind chill. But the wind at that velocity will create a higher noise level. You 
can get a good -10° wind chill at lower speeds and have a relatively quiet wind velocity.

Extension Cord

You may want an extension cord to get the Super Climater in desired positions in the room due to your 
electrical outlet locations. If an extension cord is necessary, use the shortest possible heavy-duty cord of 
14-guage wire or larger. 3 prong, 15-amp, 125-volt, 1875 watt cord. Be sure it is UL listed.

     

d.  To adjust the brightness on the LED screen:

     

    i.  Hold the 

mode button

 down until it beeps and the LED screen flashes.

     

    ii.  Press the 

arrow keys

 above the 

mode button

 to adjust the brightness of the LED screen.

    e.  To change the temperature display from Fahrenheit to Celsius:

     

    i.  Hold the 

mode button

 down until it beeps and the LED screen flashes.

     

    ii.  Press the 

timer button

 one time to change it to the opposite of what it is already on.

     

    iii. Fahrenheit temperature range is 40-90. Celsius is 1-32.

I-5468 BS7125R-1.indd   1

8/2/17   12:37 PM

Reviews: