12
IMPORTANT NOTES: Never, and we mean NEVER, attempt to do
any of the following:
•
Use Bi-Amp and Bridge Mono modes at the same time.
•
Use Inappropriate Outputs to connect speakers.
•
Switch modes of operation while the amplifier is on.
•
Connect both individual amplifier outputs to the same speaker.
(That’s what Bridge Mono is for.)
Failure to follow these precautions can cause significant damage to your
amplifier &/or speakers. We’re serious about this. Pay attention.
GETTING A GREAT TONE
As bassists, each of us has in our head a concept of our perfect sound. Eden
amplifiers are designed to help you easily achieve the sound you hear inside
you. However, it’s a multi-step process as explained below.
In order to ensure the ultimate in tone, it’s important to follow the procedure
outlined below. Don’t skip steps; don’t jump around. Yes, this may take a
minute or two, but the work is well worth it. Once they’ve done it a few
times, most users can do it time and again in about a minute.
IMPORTANT NOTE
: Before you plug in your unit for the first time,
please do the following things
.
First, turn the power switch to the OFF
position. Check the back of your unit for the correct voltage notation for
your county of operation.
Once you’ve ensured correct voltage, set the Master Volume control to
minimum (fully counter-clockwise). Set the tone controls to the center
position (12:00 or 0). Turn the Enhance control to the minimum position. Set
the Input Gain control to the minimum (fully counter-clockwise). Set the
Compressor to the OFF position (push the switch IN). This will set your
amplifier up flat and with the Compressor disengaged. Next, plug in the
power cord to the AC inlet on the back of the unit. Use only a safe grounded
receptacle for proper
operation at the
correct voltage for your country.
Double check to make certain your amplifier is set for the correct voltage in
your country. Double check that all connections and switches are correct for
your chosen mode of operation.
