STEP T WO
Layout one supporting arm and insert the four bench slats.
Slide the other supporting arm over the exposed end of the
four bench slats.
Attach the supporting bench slat on the underside of the bench
at the midpoint - invert as necessary
(2 screw points are included
per bench slat for a total of eight).
Assemble the Bench
2
3
2
EDEN ARBORS, 1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.edenarbors.com
3
2
STEP ONE
Identify a marking line at 21” above the ground on all the arbor posts.
Align the top of the bench supporting arms with the marked lines
(check to determine level) and identify the drill points necessary for
the supporting bolts.
Drill out the holes accordingly.
Drill the Arbor Posts
1
2
4
STEP THREE
Align the bench supporting arms with the pre-drilled holes
(made in Step #1)
, on the posts. The four bench slats should be
positioned towards the back of the arbor.
Slide steel galvanized hollow dowels thru the supporting arms
and into the posts
(this may require a hammer).
Insert carriage bolts from the inside of the arbor posts through
the supporting arm and install lock washer and nuts accordingly.
Insert closure cap and install screw in pre-drilled hole to lock
the cap unto the bench supporting arms. Repeat accordingly.
Connect the Assembled Bench
to the Arbor Posts
1
2
3
(Two people required for this step).
3
21”
1
1
2
3
1
3
2
1/4”
4
1
