2001 Edelbrock Corporation
Brochure No. 63-0040
©
Rev. 11/01
Page 22 of 25
6.0
Troubleshooting Your Edelbrock Nitrous System
How to use our Troubleshooting Flowchart:
The troubleshooting of a nitrous system is basic and straightforward. The symptom chart is divided by symptom, cause
and action required. Determine your problem (symptom), identify the potential problem (cause) and correct the problem
(action required).
Symptom #1…
There is No change in engine speed when fuel solenoid is activated.
1.
System wired incorrectly.
a.
Compare wiring to schematic.
i.
Wire per instructions. See page 16 for wiring schematic.
2.
Restricted fuel line.
a.
Inspect fuel line for restrictions.
i.
Remove restrictions (kinks in rubber line, pieces of rubber hanging in flow path, etc.).
ii. Change fuel line routing.
b.
Check Fuel Pressure.
i.
Increase fuel delivery as needed.
c.
Service the nitrous system fuel filter?
i.
Replace/clean fuel filter.
3.
Malfunctioning fuel solenoid.
a.
Turn arming switch on, engine off. Activate microswitch, listen for the solenoid to “click". If no
click is heard…
i.
Repair/Replace solenoid.
ii.
Check wire connections.
iii.
Verify the power is on.
iv.
Perform the wire “wiggle” test.
Symptom #2…
Change in engine speed when nitrous bottle valve is opened.
1.
Malfunctioning nitrous solenoid.
a.
Repair/replace solenoid. See solenoid inspection instructions on page 13.
2.
Contamination in nitrous solenoid.
a.
Remove and inspect solenoid for dirt around seat area of plunger in solenoid.
Symptom #3…
Engine runs excessively rich when system is activated.
1.
Nitrous bottle valve not fully opened.
a.
Check bottle valve.
i.
Open valve fully.
2.
Nitrous bottle mounted improperly.
a.
Mount bottle properly. See manual pages 7-8 for more information.
3.
Plugged nitrous filter.
a.
Clean and/or replace nitrous filter.
b.
See nitrous solenoid symptom #2.
4.
Low bottle pressure.
a.
Weigh bottle.
i.
Bottle should be 10 lbs. above empty bottle weight listed on bottle label when full.
b.
Check bottle temperature.
i.
Maintain 80 to 85 degrees of bottle surface temperature.
Summary of Contents for Performer 70070
Page 16: ......