Catalog #17934
Brochure #63-0224
Page 5 of 5
©2004 Edelbrock Corporation
Rev. 2/04 - RS/mc
WRAP UP
1. Using only equipment approved for use with gasoline,
refill the fuel tank with gasoline.
(
Note:
Always clean
any gasoline spills immediately).
2. Inspect the fuel system for leaks. Repair any leaks
before proceeding.
3. With the ignition switch off, reconnect the fuel injector
wiring harness, and reconnect the negative (ground)
cable to the battery.
4. Start the engine and inspect the fuel lines and
connections for leaks
(Note: Turn off engine and
correct any leaks before continuing.)
.
5. Clear any trouble codes in the electronic control unit
(ECU) that may exist as a result of the fuel pump
replacement procedure. Use the factory service
manual for assistance, if necessary.
TROUBLESHOOTING
Should the fuel pump fail to operate:
1. Check the fuel pump fuse and fuel pump relay as
outlined in the factory service manual.
2. If the pump has power and proper polarity, check the
remainder of the fuel system as outlined in the service
manual.
(Note: This pump will not remedy any
malfunctions in the fuel pressure regulator, fuel
injectors, or other fuel system problems).
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Technical Hotline: (800) 416-8628 • Office: (310) 781-2222
E-Mail: [email protected]
