eddyfi.com/pipescanhd
4
Detachable optical encoder
How to install and remove from scanning head
The encoder is fastened to the Pipescan on the side of the electronic module.
Install the encoder prior to deploying the head on the part to inspect to have easy access to the slot.
To do so, position the encoder’s fixation bracket in its slot and fasten using the two allen screws (1), as shown.
Connect the encoder’s connector. Make sure that red dots on connector and receptacle are aligned when doing so.
To remove, simply disconnect the connector and remove the two allen screws.
Cable
Maintenance of Scanning Heads
Magnets attract dirt. When deemed necessary during inspection or after an inspection, clean the reading surface and
magnet with soft cloth.
Do not immerse Pipescan HD.
Always follow general precautions and safety precautions during maintenance of the probe.
Wheels can also be replaced if required. If needed, spare parts can be ordered directly from Eddyfi Technologies.
Contact wheel
Pivoting arm
Fixation bracket
(Attach to pipescan HD
with 2 screws M3)
4-pin Lemo connector
Fixing screws
41-pin Amphenol connector. Head side.
I/O connector
Signal connector (160-pin array)
Drive connector
