Magg™ 480 User Manual
Document: UMDU011367.docm
Revision: A06
Created by: JS
Date: 13 Apr 2021
IPN: 3063241-A06
Source Location: C:\ePDM\ISLEng\Products\DU-MiniMag\Manuals\UMDU011367.docm
Page 28 of 38
User Ma
nual
Operation
Pre-Operations Check
Before each deployment of the
Magg™ 480 system, ensure everything is completed on the following
checklist.
❑
Check that the work area has been safely set up.
❑
Fall arrest is in place for vertical or inverted use.
❑
Check that the line voltage available at the worksite matches the equipment setup.
❑
Check that power and deck cable connections are correct.
❑
Check the vehicle for the following:
Check that the vehicle is in the correct configuration for the deployment.
Check that the magnets provide enough adhesion for the inspection geometry
Check the vehicle for mechanical damage to the chassis or cable harnesses which could affect its
operation.
Ensure that all fasteners are in place and secure. In particular, check the fasteners holding on
cameras, lights, tracks, and the harness block.
Visually inspect the vehicle and Minitracs
™ to ensure that the moving parts are free of debris and
functional. Make sure the track belt is free of debris and turns freely.
Check the tether and vehicle whips for damage.
Ensure camera, light, and laser ports are clean.
❑
Check the reel for the following:
Check that nothing will block movement of the level wind shuttle.
Check that the tether has no loose, dangling coils. Dangling coils can propagate as the drum rotates
and have the potential to jump the drum. Take care of these before deploying the tether.
❑
Power up the system and check the following:
Check for sufficient SSD drive space for recording.
Check record directories are set.
Test video recording.
Test laser lines
Test auxiliary lights.
Test track control.
Test camera control.
