Nanomag™
Document: UMAM000196.docm
Revision: A06
Created by: JS
Date: 26 Sep 2019
IPN: 3024835-A06
Source Location: C:\ePDM\ISLEng\products\am-nanomag\manuals\UMAM000196.docm
Page 8 of 19
User Ma
nual
4. Install the new belt.
5. Tension the new belt by pulling forward on the idler wheel and then tightening the Allen Flat Head
idler screw.
Re-install the wheel cover and tighten the six (6) screws again.
Magnet Installation and Removal
The magnetic strength of the vehicle can be varied by adding or removing magnets.
1. Determine North and South of each individual or entire stack of magnets. Refer to the photograph
above.
2.
Using a compass, align it with the magnets as show. When the needle shows ‘North’, the top of
the magnet closest to the compass will be north as well. Consequently, the bottom end of the
stack will be the ‘South’ end.
3.
Mark the stack with an ‘N’ and an ‘S’ accordingly.
4.
Mark each magnet with a black dot at the ‘North’ position.