The Eddy Heat Gun has three position toggle switch
marked OFF-COLD-HOT. In “COLD” position, only the fan
will operate. In “HOT” position, both the heating element
and fan operate. when switching the gun off, switch to
“COLD” position and allow fan to run for one minute before
switching to “OFF.” This procedure, when turning off gun,
will extend the life of the heating element and protect the
housing from damage.
■
Adjust heat by turning the air regulator assembly.
Your gun’s rated temperature range is based upon the
amount of air passing through the air regulator. Turning
the regulator as indicated will increase or decrease the
temperature.
■
To prevent back pressure and premature heating
element burn-out, keep nozzle at least one-inch from
surface being heated. Keep nozzle moving … do not
hold stationary on flammable materials.
■
Make certain that all ventilation openings are kept
clean and free of foreign matter. The Heat Gun is most
effectively cleaned with compressed dry air. Do not
insert objects through openings.
■
Care in handling is recommended to avoid damage to
the heating element core.
OPERATING INSTRUCTIONS
ACCESSORIES FOR HEAT GUNS
■
Shrink Tube Reflectors,
Model 1129 (left) is for
tubing up to one-inch O.D.
and Model 1130 (right) handles
up to two-inches O.D. tubing.
■
Model 1169 Sturdy circular
safety stand of LEXAN can be
easily adjusted to any angle in
horizontal or vertical position.
Easily attached and removed.
Add versatility and extra uses
to your precision unit for a
wide variety of industrial
and commercial applications.
■
Model 1155 Heat Concentrator
Attachment for limited area
coverage and efficient
shrinking of small size tubing.
■
Model 1154 Rugged polyethlylene
carrying case holds Heat Gun,
circular safety stand and
accessories.
