E-SS20/16A-I-0607
Printed in USA
TVW
©2007
Page 5
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
®
A Division of Equipment Development Company, Inc.
Operating Instructions
6 - Water Pump Switch:
(Optional) Activates pump to pull
water from an external tank when city water source is not con-
venient or available. *
7 - Depth Gauge:
Provides readout of blade depth. *
8 - Depth Control Handwheel:
Raises and lowers the blade.
9 - Speed Control:
Controls saw speed in FWD and REV. This
EDCO saw is equipped with a Hydrostatic Transmission,
which permits infi nite speed control. (Actual cutting speed is
limited by the saw blade and cutting conditions).
10 - Clutch:
Pull back to engage DRIVE. Push forward to
release drive wheels (Freewheel) SS-20. Push right to engage
DRIVE. Push to left to release drive wheels, SS-16A only.
11 - Hour Meter:
Gives readout of engine run-time. One sug-
gested use for this meter is to keep track of scheduled
maintenance. (See page 11)
12 - Handle Locks:
Loosen knobs to adjust handle posi-
tion. Be sure to securely retighten the knobs once handles are
positioned. Adjust before starting saw for operator comfort and
safe operation.
13 - Guide Rope:
Provides raising and lowering of cutting
guide.
14 - Guide Rope Cleat:
Locks Guide Rope during transit or
storage. *
1 - Emergency Stop (E-Stop):
PUSH to shut off the engine
in an emergency. Before operation, be sure the E-Stop is reset
by lifting the knob.
CAUTION:
Do not use the E-Stop as an
ON/OFF switch in place of the ignition. If the ignition is left on, it
will drain the battery.
2 - Choke:
Use to aid cold weather engine starting. Follow the
instructions in the
Engine Owner’s Manual
. *
3 - Ignition Switch:
Turn key to START position. Once engine
starts, leave in RUN position. Shut off Ignition Switch between
uses. As a safety precaution, remove key when not in use. *
4 - Throttle:
Turn COUNTER CLOCKWISE to unlock. PULL
UP to increase engine RPM, PUSH DOWN to decrease. Turn
CLOCKWISE to lock cable in position once desired engine
speed is reached.
5 - Blade Saver Switch:
Must be in the
DRY position or
engine will not start. The purpose of the Blade Saver is to stop
the engine if water pressure drops. If using a WET CUT Blade,
open the water valve and select the WET position after starting
the engine and before starting to cut. *
Figure 2
6
Water Pump
Switch
12
Handle
Locks
3
Ignition
5
Blade Saver
Switch
1
Emergency Stop
(E-Stop)
10
Clutch
9
Speed
Control
1
Emergency Stop
(E-Stop)
10
Clutch
7
Depth
Gauge
12
Handle
Locks
4
Throttle
8
Depth Control
Handwheel
11
Hour
Meter
2
Choke
9
Speed
Control
13
Guide
Rope
8
Depth Control
Handwheel
13
Guide
Rope
4
Throttle
14
Guide
Rope
Cleat
Note:
Numbers coincide with the
Guide To
Operation
label on the SS-20 machine only.
Note:
* Not available on SS-16A console.