5
EN
CIRCUIT
™
INSTALLING TRANSMITTER BATTERIES
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
TRANSMITTER CONTROLS
2.4GHZ DIGITAL
RADIO SYSTEM
1
2
11
1. Steering
Wheel
Controls direction (left/right) of the model
2. Throttle
Trigger
Controls speed and direction (forward/brake/reverse)
of the model
3. ON/OFF
Switch
Turns the power ON/OFF for the transmitter
4. Throttle Limiting Switch
Adjusts the throttle limit from 50%, 75%,
and 100%
5. TH
Rate
Adjusts the end point of the throttle
6. TH
Trim
Adjusts the throttle neutral point
7. TH
REV
Reverses the function of the speed control when pulled back
or pushed forward
8. ST
REV
Reverses the function of the steering when the wheel is turned
left or right
9. ST
Trim
Adjusts the steering center point
10. ST Rate
Adjusts the end point of the steering
11. Antenna
Transmits the signal to the model
12. Indicator Lights
• Solid red lights—
indicates radio connectivity and adequate
battery power
• Flashing red lights—
indicates the battery voltage is critically
low. Replace batteries
3
4
8
7
9
6
10
5
12
CAUTION:
NEVER remove the transmitter batteries
while the model is powered on. Loss of model
control, damage or injury may occur.
CAUTION:
If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in injury
to persons and/or damage to property.
CAUTION:
Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to
state and local laws.