ECTACO SpeechGuard™ GI-4
User Manual
23
♦
Note:
The system will adapt to the speaker voice only after all
the adaptation phrases are recorded.
Check the Power Supply
ECTACO SpeechGuard™ GI-4 is powered by a Li-Polymer
rechargeable battery (3.7V, 1800mAh). The battery compartment
is located on the back of the device and is covered with a plastic
cover (see
Back Panel
on page 5).
To open the battery compartment, unscrew two screws, holding
the battery compartment cover.
♦
Note:
If the battery power runs too low, the warning message
will be displayed. To restore full functionality of the device and
avoid risk of losing user data, recharge the battery as soon as
possible.
The device works up to 1 week without recharging (in sleep mode)
or up to 8 hours of active use. The automatic turnoff has a preset
delay of 5 minutes. This feature saves battery life by shutting the
device down after the specified period of inactivity (see
Tweak the
System
on page 20)
♦
Note:
Before you plug in the AC/DC adapter, please make sure
that the battery is inserted in the battery compartment.
Install MMC
ECTACO SpeechGuard™ GI-4 MultiMedia Card is included in the
standard package. The card contains data necessary for proper
functioning of the device.
The MMC slot is situated under the battery in the battery
compartment. If the MMC is not installed, please follow the steps
below to install it.
♦
Note:
Always make sure the device is turned off before
installing or removing the MMC. Use the
On/Off
button to turn
the device off.
1.
To open the battery compartment (see
Back Panel
on page 5),
unscrew two screws, holding the battery compartment cover.
2.
Remove the battery from the compartment.
3.
Slide the MMC into the MMC slot with the label face up and the
contacts face down.