ECTACO
®
jetBook
®
mini
User
Manual
2
ECTACO, Inc. assumes no responsibility for any damage or loss resulting from the use of this manual.
ECTACO, Inc. assumes no responsibility for any loss or claims by third parties, which may arise through
the use of this product.
ECTACO, Inc. assumes no responsibility for any damage or loss caused by deletion of data as a result of
malfunction, repairs, or battery replacement. Be sure to back up all important data on other media to avoid
data loss.
The contents of this manual as well as software functionality are subject to change without prior notice.
No part of this manual shall be reproduced, stored in a retrieval system, or transmitted by any means,
electronic, mechanical, photocopying, recording, or otherwise, without permission from ECTACO, Inc.
jetBook
®
is a registered trademark of ECTACO, Inc., NY, USA.
© 1990–2011 ECTACO, Inc., New York, USA.
All rights reserved.
Expat by Thai Open Source Software Center Ltd. Zlib by Jean-loup Gailly and Mark Adler. Libungif by Eric
S. Raymond. Libjpeg by Thomas G. Lane. Libpng by Glenn Randers-Pehrson.
The names of actual companies and products mentioned herein may be the trademarks of their respective
owners.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
