16
3.
Plug the correct connector on the FDD cable for the 5.25-inch or 3.5-inch drive
into the FDD connector (
B
).
4.
Plug a power cable from the case power supply into the power connector on
the FDD (
C
).
When you first start up your system, go immediately to the Setup Utility to
configure the floppy diskette drives that you have installed. See Standard
CMOS Features on page 27 for more info rmation.
Installing Add-on Cards
This mainboard has three 32-bit PCI (Peripheral Components Interconnect)
expansion slots, one 4xAGP slot, and one Communications and Networking
Riser (CNR) slot.
PCI Slots
PCI slots are used to
install expansion cards
that have the 32-bit
PCI interface.
4xAGP
Slot
The 4xAGP slot is used
to install a graphics
adapter that supports
the 4xAGP
specific ation and has a
4xAGP edge
connector.
CNR Slot
This slot is used to
insert CNR cards with
Modem and Audio
functionality.
PWRFAN1
D
I
M
M
1
ATX1
A
TX
2
CDIN1
AGP1
PCI1
PCI2
PCI3
CNR1
J3
JP2
L
U
S
B
2
LUSB1
WOM1
FLOPPY1
CDIN2
LMDN1
COM2
L
A
U
D
IO
1
1
1
1
1
1
AGP Slot
PCI Slots
CNR Slot
Note:
Before installing an add-on card, check the documentation for the card
carefully. If the card is not Plug and Play, you may have to manually
configure the card before installation.
Follow these instructions to install an add-on card:
1.
Remove a blanking plate from the system case corresponding to the slot you
are going to use.
2.
Install the edge connector of the
add-on card into the expansion
slot. Ensure that the edge
connector is correctly seated in
the slot.
3.
Secure the metal bracket of the card to the system case with a screw.
Add-on
card
Edge
connector