ECS A13G Series, User Manual, Page: 31 / 47

28
Motherboard User’s Guide
Phonex-AwardBIOS CMOS Setup Utility
DRAM Configuration
Help Item
Menu Level
f
f
Onboard GPU [Enable If No Ext GPU]
Frame Buffer Size [64M]
GPU Bank Flip [Disabled]
PMU
[Disabled]
CPU Frequency [200.0]
K8<->NB HT Speed [Auto]
K8<->NB HT Width [Auto]
DRAM Configuration [Press Enter]
PCIE Spread Spectrum [Disabled]
SATA Spread Spectrum [Disabled]
HT Spread Spectrum [Disabled]
PCIE Clock [100Mhz]
SSE/SSE2 Instructions [Enabled]
TPM Control [No Change]
System BIOS Cacheable [Disabled]
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F5: Previous Values F6: Fial-Safe Defaults F7: Optimized Defaults
Timing Mode
This item allows you to set up the DRAM timing nanually or automatically.
DQS Training Control
Memory Clock value or Limi
When DDR2 Timing Setting by is set to Manual, use this item to set the DRAM
frequency.
CKE based powerdown
The DRAM channel is placed in power down when all chip selects associated
with the channel are idle.
Memclock tri-stating
This item enables or disables memclock tri-stating function.
Memory Hole Remapping
This item allows users to enable or disable memory hole remapping.
Auto Optimize Bottom IO
This item is used to set the Auto Optimized Bottom IO.
Bottom of [31:24] IO space
This item is used to select the memory that will be remapped higher than 00E0.
Bottom of UMA DRAM [31:24]
This item is used to set the bottom of UMA DRAM [31:24]. We strongly
recommend that you leave this item at its default setting.
DQS training is used to place the DQS strobe in the center of the data eye.
CKE base power down mode
When in power down mode, if all pages of the DRAMs associated with a CKE
pin are closed, then these parts are placed in power down mode. Only pre-
charge power down mode is supported, not active power down mode.