ECS 965PLT-A, Manual

Page: 26 / 50

20
Installing the Motherboard
1. Open the chassis and then remove the slot bracket from the case where you will be
installing the expansion cards.
2. Install your graphics card in the proper slot by pressing the card firmly into the
slot.
3. Drive in the screw to secure the slot bracket of the expansion card.
4. Replace your computer’s chassis cover.
5. Power on the computer, if necessary, set up BIOS utility of expansion card from
BIOS.
6. Install related driver to complete the installation.
Installing two graphics cards
Follow these instructions to install add-on cards:
Express Graphics cards at hand, set them up onto PCIEX1 and PCIEX3 slots si-
Notes: 1. The two PCIEX16 (x16 and x4 mode) slots run in two modes. With only one
PCI Express Graphics card, install it onto PCIEX1 slot by default. Having two PCI
multaneously.
2. The Scalable D.G.E. supports a four-monitor configuration when PCIEX1 slot and
PCIEX3 slot are working simultaneously.
3.Please note that the graphics card driver supports Windows 2000/XP only.
4.Make sure to connect a 4-pin ATX power cable to the ATX4P1; otherwise,
the system will be unstable.