38
Using BIOS
PCI PIRQ[A-D]# (Disabled)
When disabled, any PCI device set as the Master will not power on the system.
Delay Prior to Thermal (None)
Enables you to set the delay time before the CPU enters auto thermal mode.
Reset Configuration Data [Disabled]
If you enable this item and restart the system, any Plug and Play configuration data stored in the
BIOS Setup is cleared from memory.
Resources Controlled By Auto [Auto(ESCD)]
You should leave this item at the default Auto (ESCD). Under this setting, the system dynamically
allocates resources to Plug and Play devices as they are required.
If you cannot get a legacy ISA (Industry Standard Architecture) expansion card to work properly,
you might be able to solve the problem by changing this item to Manual, and then opening up the
IRQ Resources submenu.
IRQ Resources [Press Enter]:
In the IRQ Resources submenu, if you assign an IRQ to Legacy ISA, then that Interrupt Request
Line is reserved for a legacy ISA expansion card. Press <Esc> to close the IRQ Resources
submenu.
Press <Esc> to return to Power Management Setup page.
Press <Esc> to return to CMOS Setup Utility page.
PNP/PCI Configurations
These options configure how PnP (Plug and Play) and PCI expansion cards operate in
your system. Both the the ISA and PCI buses on the motherboard use system IRQs
(Interrup ReQuests) and DMAs (Direct Memory Access). You must set up the IRQ and
DMA assignments correctly through the PnP/PCI Configurations Setup utility for the
motherboard to work properly. Selecting PnP/PCI Configurations on the main program
screen displays this menu:
Phoenix-AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
Reset Configuration Data
[Disabled]
Resources Controlled By
[Auto(ESCD)]
IRQ Resources
Press Enter
PCI/VGA Palette Snoop
[Disabled]
Assign IRQ For USB
[Enabled]
INT Pin 1 Assignment
[Auto]
INT Pin 2 Assignment
[Auto]
INT Pin 3 Assignment
[Auto]
INT Pin 4 Assignment
[Auto]
INT Pin 5 Assignment
[Auto]
INT Pin 6 Assignment
[Auto]
INT Pin 7 Assignment
[Auto]
INT Pin 8 Assignment
[Auto]
Item Help
Menu Level
X
Default is Disabled. Select
Enabled to reset Extended
System Configuration Data
ESCD) when you exit Setup if
you have installed a new add-
on and the system
reconfiguration has caused
such a serious conflict that
the OS cannot boot
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
FDD, COM, LPT Port (Disabled)
When this item is enabled, the system will restart the power-saving timeout counters when any
activity is detected on the floppy disk drive, serial ports, or the parallel port.