See Next Page
C
aref
ul
l
y
R
ot
a
te
U
p
1
Attach Upper Rail to Top Panel
2
Install Lower Rail to Bottom Panel
3
Install the Left Side Panel
4
5
Insert the Back Panels
Insert the Frame Wall Mount
Place two
Cam Locks (M2)
into the
recessed holes on the backside of
Upper Rail (G)
, with the arrow facing
the closest edge.
Attach the Upper Rail onto the Cam
Posts on the underside of the
Top
Panel (B)
as shown, turn the Cam
Locks clockwise with a Phillips
screwdriver to lock the Upper Rail
onto the posts.
Install two
Cam
Posts (M1)
into the threaded plastic inserts on the underside of
Top Panel (B)
with a Phillips screwdriver.
Reminder:
Do not overtighten as the plastic threads can be stripped.
Install the
Lower Rail (H)
to the
Bottom Panel (C)
with two
Long
Hex Screws (L)
using the Hex Tool.
Note
: The two wide channels on the
Lower Rail should face toward the
backside of the unit.
Install the
Left Side Panel (A1)
to the
Top Panel (B)
and
Bottom Panel (C)
with four
Long Hex Screws (L)
using
the Hex tool.
Note
: The pre-installed wooden
dowels in the Upper & Lower Rails fit
into the corresponding holes that are
not drilled thru the side panels.
Two Adults Recommended:
Rotate
the unit onto the
Left Side Panel (A1)
.
Insert the pre-installed wooden dowels on the
Frame Wall Mount (E)
into the holes on the
Left Side Panel (A1)
first, then into the
Top Panel (B
).
Slide one
Back Panel (J)
into the
grooves on the
Top Panel (B) &
Bottom Panel (C)
as shown, until
fully seated into the groove on the
inside of the
Left Side Panel (A1)
.
Note:
The small holes on the
Back Panels should be placed on
the bottom of the unit.
Insert an
H Connector (I)
onto the
edge of the first Back Panel, this
will nest into the wide channels on
the Upper & Lower Rails. Repeat
for the remaining Back Panels.
Tip:
If the Back Panels do not
slide in easily, wiggle the panels
while pushing into place.
Batch ID Sticker
Small holes
go at bottom