5
Black Cable
Red Cable
Loosen Bolts
Tighten Bolts
Installation: Gas Vehicle
1. Loosen the bolts on the
battery terminals.
Use Caution:
Do
NOT
attempt to loosen
bolts if battery is wet. Contact may
cause electric shock and injury if wet.
2. Connect the
BLACK
wire to the
BLACK
, negative terminal, then
the
RED
wire to the
RED
, positive
terminal. Unit will not work correctly
and may be damaged if wires are not
correctly attached.
3. Tighten the bolts on the battery
terminals until the connectors are
held firmly in place.
4. Return the 15 Amp Blade Fuse into
the Fuse Holder and close the cap.
Installation: Electric Vehicle
1. Switch your vehicle to TOW mode.
2. Loosen the bolts on the
battery terminals.
3. Connect the
BLACK
wire to the
GROUND
on the DC-DC Converter,
then the
RED
wire to the
POSITIVE
(
+
) post on the DC-DC Converter.
Unit will not work correctly and
may be damaged if wires are not
correctly attached.
4. Tighten the bolts on the battery
terminals until the connectors are
held firmly in place.
5. Return the 15 Amp Blade Fuse into
the Fuse Holder and close the cap.
Tip:
Use zip ties to gather any excess
wires, and secure them so that they are
not dangling, loosely.