Set Up
Recommendations 1-2-3
Charge Your
EcoRoam 30
Before you power on your
EcoRoam 30, connect the USB
Micro port to the USB cable
and a 5V, 1A power source to
fully charge your EcoRoam 30
for best performance.
NOTE:
Before using your EcoRoam
30 for the first time, charge the unit
until all battery level indicators are
green, indicating a full charge.
Approximately 3 hrs. of charging is
required from a low to a full charge.
Power source options include the
USB connection to your computer
or a power outlet using a 5V, 1A
USB to AC power adapter. It is
recommended to always use the
USB cable included with your
EcoRoam 30.
1
receiver is connected, consult the dealer or an
experienced radio/TV technician for help.
RF WARNING STATEMENT:
The device has been evaluated to meet
general RF exposure requirement. The device
can be used in portable exposure condition
without restriction.
IC STATEMENT:
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
PRODUCT USE AND PROTECTION:
Read and follow all instructions.
Use only as intended.
The ECOXGEAR Bluetooth speaker is intended
to be used indoors or outdoors and in land
or water environments. The speaker has been
tested to IP67 waterproofing standards, which
means the speaker can be submerged in up
to 3 feet of water for 30 minutes without any
damage. However, the speaker is
NOT
intended
for constant underwater use.
Always make sure the cap(s) / covers(s) are
clean, free from sand or debris, and correctly
fitted. The speaker will only meet IP67 ratings if
all rubber seals, gasket(s), and cover(s) / cap(s)
are in place. If you notice a muffling of audio
after submersion, gently shake the unit to clear
excess water. If your speaker is exposed to salt
