2
3
Power On, Battery, & LED Status Indicators
Once fully charged, press the Speaker or Lantern Standby
Power Buttons
/
on the front of your
EcoLantern. When powering on, you will see the battery
indicator LEDs and, if the speaker is turned on, you will hear,
“Speaker On, Ready to Connect.”
IMPORTANT:
Make sure that the Master Power Switch,
located in the back compartment under the cap, is set in
the ON position. If the switch is in the OFF position, your
EcoLantern will not be able to turn on using the Standby
Power Button.
The LED battery level indicators are located on the front of
the unit. Each bar represents 25% of a charge, with 4 full
LEDs indicating a full charge.
Audio playback time over Bluetooth connection is
approximately 20 hours at 75% volume. Light operating time
is approximately 8 hours at 50% brightness.
Bluetooth Pairing & Your Audio
Connecting With Bluetooth:
Connect To Your Smart Device & Play Audio
When the speaker is turned on, the blue LED light on the
front panel will flash, indicating the unit is ready to pair.
Turn on Bluetooth on your Bluetooth device (Smart Device)
and set the device in pairing mode. Available Bluetooth
connections shall appear. Select the ECOXGEAR speaker
from the list of discovered devices on your Bluetooth device.
Wait for a few seconds until the connection is completed.
NOTE:
Bluetooth connection feature is found in the
Settings section of most mobile phones and other
Bluetooth enabled devices.
When the ECOXGEAR selection is made and the Bluetooth
connection is completed, your EcoLantern will announce:
“Connection successful”
Once connected, select and play your desired audio.
