Ecox EPTC, Installation Manual, Page: 8 / 20

8
NPTC / EPTC
CEILING AND FLOOR TYPE
The piping length between the outdoor unit and the indoor
unit may not exceed the allowable piping length.
In the case that the installation place is exposed to strong wind
such as a seaside, make sure the fan operating properly by
putting the unit lengthwise along the wall or using a dust or
shield.(Refer to Fig.6-1).
If possible, do not install the unit where it is exposed to direct
sunlight.
If necessary, install a blind that does not interfere with the airflow.
During the heating mode, the water drained off the outdoor
unit. The condensate should be well drained away by the drain
hole to an appropriate place, so as not to interfere other people.
Select the position where it will not be subject to snow drifts,
accumulation of leaves or other seasonal debris. If unavoidable,
please cover it with a shelter.
Locate the outdoor unit as close to the indoor unit as possible.
If possible, please remove the obstacles nearby to prevent the
performance from being impeded by too little of air circulation.
The minimum distance between the outdoor unit and obstacles
described in the installation chart does not mean that the same
is applicable to the situation of an airtight room. Leave open
two of the three directions. (Refore to Fig.6-7, Fig.6-8, Fig.6-9).
NOTE
Str
ong wind
FIG. 6-1
The dimension of 12 and 24 are the same
The dimension of 30 and 36 are the same
The dimension of 48 and 60 are the same
6.2 FIGURE OF bODy SIzE
1
FIG. 6-2
FIG. 6-4
FIG. 6-3
A
A
H
H
B
F
E C D
Split type outdoor unit
See table 6-1