13
degree angle and has a curved profile (which will end up “hugging” the
mounting pole). Once the metal plate is inserted, remove nuts from the U-
Bolts and insert both U-bolts through the respective holes of the metal plate
as shown in Figure 6.
Figure 6: U-Bolt installation
Loosely screw on the nuts on the ends of the U-bolts. You will tighten these
later during final mounting. Final assembly is shown in Figure 7.
Figure 7: U-Bolts and nuts installation
The plate and U-Bolts are not yet needed at this stage but doing this now
may help avoid damaging wind vane and wind speed cups later on. Handling
Summary of Contents for GW1002
Page 38: ...38 Dashboard Graph display ...
Page 39: ...39 List display Weather Map ...
