18 |
P a g e
Part
–
5: MAINTENANCE & CLEANING
Cleaning the unit
1.
Turn off the power before cleaning the unit.
2.
Gently wipe dirt and stains with a dry soft cloth
or sponge.
3.
Do not apply any chemical solutions to the
unit.
4.
Turn on the power after clean the unit.
Cleaning the nozzle
1.
Press the NOZZLE CLEANING button on the
remote control, or REAR CLEANSING button
on the side of the unit. The wand will
stretch out.
2.
Clean the nozzle with a dry soft cloth or
sponge.
3.
Press and hold NOZZLE CLEANING button on
the remote control, or REAR CLEANSING
button on the side of the unit, nozzle will
start self-rinsing.
4.
Press again to stop self-cleaning.
Warning
:
Do not apply force by pulling, pushing or
attempt to bend the nozzle, this will result in damage
or electrical shock.
Cleaning the filter
1.
Power off the unit.
2.
Unplug power cord with dry hands.
3.
Unscrew the filter as shown in the picture.
4.
Rinse with clean water, use a brush if
necessary.
5.
Install the filter back to its original position.
6.
Check for leakage.
Replace the water from tank
When room temperature is below 0
°
C/32°F or
electricity is disconnected for a long time, the
water in the tank has to be discharged.
1.
Turn off the power and open the tank cover,
press push the discharge button in to discharge
water.
2.
When finished, press down the round button
inside the discharge button to turn off the
discharge valve then close the tank cover.
Note:
The power must be turned off before
discharging the tank
