7
ENG
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2015
To begin installing the faucet drill a hole with a
diameter of 12.5 mm (1/2’’) in a suitable place on the
kitchen sink or counter.
Assemble the faucet on the counter top by first putting
the rubber gasket on top of the hole and seating the
faucet in it. Put on plastic gasket, lock washer, and nut
on the faucet shank sticking through at the bottom
side of the hole. Screw the nut all the way up until the
faucet is firmly fixed on the counter top.
Take the blue tube, put compression nut on it, put on
compression ring, then put plastic insert inside the
blue tube (in that order).
Push the blue tube into the bottom of the faucet
shank ensuring the compression ring is stuck in the
bottom of shank. Screw on the compression nut in
order to join the tube to the faucet.
After completing the installation the faucet must be
firmly fixed on the countertop, and the blue tube
firmly joined to the threaded connection of the faucet.
Faucet installation
Connecting flexible tubes
Connecting the flexible tubes does not require using
any tools. The entire system is connected together per
scheme on page 8.
1.
In order to join tube to fitting simply push the
tube all the way into the fitting.
2.
After you have joined the tube, put on
a locking clip (horseshoe-shaped red
plastic clip) under the collet to secure the
connection.
3.
Check the connection you have made by
pulling on the tube in outward direction.
4.
If you need to release tube from connection,
take off the locking clip, push the collet back
against the fitting, and then gently pull out
the tube, while keeping the collet depressed.
Attention! Metal chips can damage the sink, it is necessary to remove them carefully after the hole is drilled. If you are installing the
faucet on a ceramic or stone fixture, use a special carbide drill bit.
Summary of Contents for 3-STAGE
Page 13: ......
