ECOScience 6300wt, Installation And User Manual

Page: 25 / 84

11
ECOScience ENERGY CENTRE INSTALLATION AND USER MANUAL
© ECOScience
E
d
ition:
0
1
; La
st
upda
ted
: 201
1-
04-1
2
Top connected system tank, CS300
4.3 ASSEMBLING THE SUPPORT BASE AND SYSTEM
TANK
4.3.1 Instructions
1. Ensure that the space intended to house the product is large
enough and that the floor is capable of bearing its weight. A clear
height of approximately 300 mm above the system tank is
recommended in order to facilitate the installation and adjustments.
For dimensions see ‘10 TECHNICAL DATA’ on page 51.
2. Remove the product from the packaging and carefully check that no
damage has occurred during transport/handling.
3. Lift out the support base and check that all 6 adjustable feet (1 of
which is spare) have been included.
4. Attach the feet to the support base.
5. Place the support base where the tank is to be installed.
6. Check that the support base sits flat using a spirit level as shown in
according to ‘Figure 4. Spirit level check’.
Figure 4. Spirit level check
7. Lift the product off the pallet and place it over the support base.
8. Check that the support base is positioned directly under the tank.
9. Check that the product is not obstructed by any surrounding
equipment/structures.
10. Check again that the product sits flat using a spirit level, adjust the
feet if necessary.
PLEASE NOTE: SPACE FOR
INSTALLATION!
There must be a floor drain where the system tank and
buffer tank are housed.
CAUTION: RISK OF INSTABILITY!
Check that the product sits flat after it has been filled
to ensure its stability.