Ecoplus 727184, Instruction For Installation And Maintenance, Page: 6 / 12

6
THE PUMP MUST BE SUPPORTED BY A BASE. NEVER SUSPEND THE PUMP FROM PIPES.
3. MANAGEMENT
3.1 Storage:
Pump must be stored in a dry, dust free covered area that is free from
vibrations. Keep the pump in its original packaging until time of installation.
3.2 Transport:
Avoid subjecting the pump to needless impacts and collisions.
4. WARNINGS
Do not carry pump by the power cable. Always carry pump using the handle.
• Never allow the pump to run dry.
• The sealing device contains a non-toxic lubricant which may alter the characteristics of pure
water in the unlikely event of leaks.
5. INSTALLATION
The electrical system must be compliant with local codes .
Screw on the elbow with hose-tail fitting provided. Use a
pipe tightening clamp to secure the pipe to the fitting.
• If the bottom of the trap where the pump is to be placed
is particularly dirty, a raised support should be provided
so as to avoid blocking of the suction grid (Fig.1)
 • Totally immerse the pump in the water.
• Ensure that the minimum dimensions of the trap in
which it is housed are as follows:
Min. base dimensions 7.87”x7.87” (200x200 mm)
Min. height 15.75” (400 mm)
• The dimensions of the trap must always be in relation
to the quantity of water arriving and to the flow of the
pump, so as not to subject the motor to excessive
starts/hour. It is strongly recommended not to
exceed 20 starts/hour.
ALWAYS INSTALL THE PUMP IN VERTICAL POSITION.
6. ELECTRICAL CONNECTION
The length of the power cable limits the maximum depth of pump immersion.
Follow the indications on the technical data plate and technical specifications on page 3.
(Fig.1)