13
Fault code
Code meaning
Reason
Solution
E001
Controller stops working
temporarily
Block
Rear wheel is stuck
E002
Controller stops working
temporarily
Undervoltage or overvoltage
The battery is exhausted or the battery voltage is too high.
Please check the charger. Not solved,please contact your
local dealer.
E003
Controller stops working
temporarily
Overcurrent
Not solved,please contact your local dealer.
E004
Controller stops working
temporarily
Controller over temperature
Please drive the scooter to a cool place to avoid intense
driving
E005
Controller failure
Power tube failure, drive power failure
Please contact your local dealer.
E006
Controller verification
failed
Illegal controller and controller failure
Use original factory controller
E007
Motor failure
Encoder failure, lack of phase
Please contact your local dealer.
E008
Battery overcharge
protection
Charge saturation protection
Check if the charger is damaged; check if the charger model
matches the corresponding model. If not solved, please
contact your local dealer.
E009
Charging overcurrent
protection
Charging overcurrent protection
Check if the battery is used for the specified model. If not
solved, please contact your local dealer.
E010
Low temperature prohibits
charging
Below 0°C for 30s, below -20°C for 3s
Please put the battery in indoors and it will recover after the
battery temperature is higher than 3 °C.
E011
Battery over discharge
warning
The battery is about to run out, and the
BMS is about to enter the over-discharge
protection.
Charge the battery with the charger
E012
Discharge over flow alarm
The battery current reaches the protection
value, and the BMS is about to overcurrent
protection
Please check if the battery is used for the specified model. If
not solved, please contact your local dealer.
E013
Battery over temperature
warning
The battery temperature is about to reach
the protection value, and the BMS is about
to enter the over temperature protection.
Please take out the battery and put it in a cool place. When
the battery is cooled to below 60 °C, it can be used again.
E014
Low temperature prohibits
charging and discharging
The battery cell is lower than -20 °C for 5s
continuously
Please remove the battery. You can return to use it after the
battery is above -15 °C.
E015
Accelerate handle grip
failure
Accelerate handle grip failure
Please contact your local dealer.
E016
Controller communication
failure
Controller has no feedback data
Please contact your local dealer.
E017
Controller communication
failure
Battery has no feedback data or error data
Please check if the battery plug connection is tight.
If not solved,please contact your local dealer.
E018
Controller communication
failure
Central control failure, main wires failure
Please contact your local dealer.
E019
Controller communication
failure
SIM card recognition failed
Please contact your local dealer.
E020
Controller communication
failure
Communication module failure
Please contact your local dealer.
E021
Controller communication
failure
GPS failure
Please contact your local dealer.
E022
Controller communication
failure
GPS antenna short circuit
Please contact your local dealer.
Summary of Contents for E1+
