AG
90.0°
DETAIL AU
SCALE 1 : 5
IDEAL FLANGE
ORIENTATION
AV
PR
ON CENTER DISTANCE
MUST MATCH ACCESSORIES
LOOSELY
SECURED
SHORT SET
SCREW
(PRE-INSTALLED)
- WITH AT LEAST 2 PEOPLE, POSITION
THE ASSEMBLED UPRIGHT AGAINST THE
WALL.
- ADJUST THE LOWER CONNECTOR TO
AVOID ANY WALL MOLDINGS AND
SECURE THE HEIGHT BY TIGHTENING
THE INSTALLED SHORT SET SCREW.
- USING A LEVEL, CHECK THAT THE POST
IS PLUMB.
-MARK AND SECURE THE WALL FLANGES
TO THE WALL AS REQUIRED WITH
APPROPRIATE HARDWARE.
NOTE: FOR MAXIMUM STRENGTH, THE
PIPE FLANGE SHOULD BE ORIENTED AS
SHOWN ABOVE.
- BE SURE THE LEVELER IS FIRMLY
CONTACTING THE FLOOR. IF NOT,
UNTHREAD UNTIL IT IS.
- THE REMAINING UPRIGHT MUST BE
POSITIONED SO THE DESIRED
ACCESSORIES CAN BE USED.
- FOLLOW THE PRIOR STEPS TO
ASSEMBLE AND INSTALL ANY REMAINING
POSTS.
NOTE:
STANDARD ACCESSORY SIZES ARE
24" AND 48" O.C.
- IT IS RECOMMENDED TO LOOSELY
SECURE THE NEXT POST TO THE WALL SO
AN ACCESSORY CAN BE TESTED.
- IF IT IS DIFFICULT TO INSTALL OR
REMOVE, THE UPRIGHT MAY NEED TO BE
ADJUSTED.
- IF THE ACCESSORY IS NOT LEVEL, THE
UPRIGHT LEVELERS MAY NEED TO BE
ADJUSTED.
- IF ACCESSORIES ARE NOT AVAILABLE,
USE A TAPE MEASURE TO CHECK THE ON
CENTER DISTANCE.
RECOMMENDED BUT
NOT MANDATORY
3
SECURE FIRST POST TO THE WALL
4
SECURE REMAINING POSTS WHERE THEY ARE REQUIRED
SECURING LOWER
CONNECTOR
PSOR
SHEET 3 OF 3
PSOR
