24
can now be removed and cleaned. When it has
been cleaned replace the ring switch and rotate
it until it engages firmly in place (magnet must
be positioned on the shaft - ecom address side).
The lamp head can then be screwed back onto
the flashlight.
8.5 LED replacement
The Lite-Ex PL 10 is equipped with a long-life
LED bulb. Under normal conditions it is not
necessary to change the LED. If, however, the
torch is defective or the brightness of the torch
has diminished, it should be sent to ecom instru-
ments for inspection or repair. The LED housing
should not be opened!
Manipulating the torch head or LED on your own
poses a risk to the safety of the flashlight and is
not permitted.
8.6 Replacing the protective disc
The LED housing is protected by the surrounding
housing head and an additional protective disc,
which is located over the opening where the
beam is emitted. The disc is made of high-quality
material. Should, however, the disc break, it is
possible to replace it. To do this grasp the body
of the Lite-Ex PL 10 and the ring switch and
then carefully unscrew the lamp head by turning
it anti-clockwise. To unscrew the lamp head
from the LED housing use an Allen key (AF4) to
secure the LED housing in place (see Fig. 2) and
unscrew the lamp head. The sealing ring can
now be replaced (only use original ecom sealing
rings). The LED housing should then be cleaned
thoroughly and the sealing ring checked for
signs of damage. If the sealing ring exhibits any
damage, it should also be replaced (the sealing
