19
- Set the MR/MW button to tuning or storing
- Press the SC/DW button and release again. You will hear a receiving tone.
The search begins at the same time and the changed channel numbers or
frequencies can be recognized on the display.
The scan direction can be adjusted with the UP or DOWN buttons. The search
stops at the next occupied channel. The strength of signal can be adjusted via
squelch location function so that it stops. When stopping, the decimal point flas
hes between 1-MHz and 100 kHz places of the frequency indicator or for the
channel indicator between H and the connection line. The indicator BUSY
appears later, top left of display. After a good 5 seconds, the search
automatically starts again – if the signal is received.
If you wish to stop the search at the indicated channel, simply give the SC
button a short press. You can also stop the search by pressing the PTT button.
Advice; The search can then only start its memory running if at least two storage
spaces are occupied.
Search; jumping channels
If the search repeatedly stops at channels that don`t interest you, these channels
can be jumped;
- If it stops simply press the FUNC button – short indicator delete, before the
search continues.
When tuning one can tune up to 7 channels, when memory running, up to 9 chan-
nels. Afterwards, the indicator reads EMPTY. After the equipment is switched on
and off, these markings to jump will disappear again automatically.
Display-lighting on/off (also permanent).
The lighting display can be read better in the dark by switching on the /BP
button.
Press the /BP button and then release. The light will be switched on with
reception tone for about three seconds and will then disappear automatically.
Because it is automatic, the battery power will be saved.
If you hold the button for longer than 2 seconds, the display lighting will remain
on until the button is pressed once more and switched off.
Electronic locking buttons/unlocking
To prevent operational errors, the buttons can be locked electronically. It will also
prevent inadvertent adjustments of channels during reception.
Press the FUNC button and simultaneously press the PS/LOCK button –
indicator appears top right on the display.
Now all buttons are locked (apart from MO/Fr/Ch and PTT).
To unlock the buttons; Press the FUNC button and simultaneously press the
PS/LOCK button.
Indicator disappears from the top right of the display.
