© 2016 Ecolink Intelligent Technology Inc.
PN FF-ZWAVE5-ECO
Network Inclusion/Exclusion: Key Points to Remember
Controller inclusion mode must be activated BEFORE starting sensor inclusion or exclusion mode.
The sensor can only be included into one controller network at a time, and must be excluded from one network before inclusion in
another
Exclusion mode on the senor is initiated following the same exact procedure as inclusion.
LED Status
The FireFighter
tm
is equipped with a multi-color LED. The state of the LED will change based on the state of the device.
Insert Battery
= One(or two, if in CO mode below) RED blink, then one GREEN blink
Device not included
= Green light breathing (slow blink)
Learn button pressed = Solid Yellow (red + green) while in learn mode.
Sound detected
= Flash YELLOW for the duration of the sound
File Alarm Detected
= Solid RED for 3 seconds, then blink red while tone detected
Case Opened
= Red/Green breathing until case closed (while added to a network)
C0 Alarm Detection
In addition to Smoke Alarm detection, the device can detect the presence of a carbon monoxide alarm. By default, the
sensor is not guaranteed to detect a CO alarm. The device can be configured to more reliably detect a CO alarm in
exchange for a reduced battery life. This mode can be changed by holding down the tamper switch and learn button for
10 seconds. The device should then be reset ( remove battery and replace ) in order to determine the current device
setting.
RED + GREEN
= Device will not reliably detect CO, but standard battery life
RED + RED + GREEN
= Device will more reliably detect CO, but with reduced battery life.
Factory Default
The FireFighter™ can be restored back to factory default settings which will remove its Z-Wave Plus node ID from the
sensor (but not the controller) with the following steps. Please use this procedure only when the network primary
controller is missing or otherwise inoperable.
1)
Put the battery into the sensor.
2)
Do not press the tamper switch.
3)
Hold the learn button down for 10 seconds until the LED turns RED.
4)
Release the learn button and wait for the sensor’s green LED to “breath” on and off continuously. The sensor is now
ready to be added to a Z-Wave Plus network, and all settings have been restored.
