Ecolab MULTILINE 1000-S, Operating Instructions Manual, Page: 69 / 114

9 Troubleshooting
Fault description Cause Remedy
Unit not functioning Incorrect mains voltage Check metering unit settings (see
Ä
Chapter 6.1.1.1 ‘Setting of
mains voltage’ on page 21 )
Defective fuse Replace fuse
‘Product: Reserve’
appears on display
‘Reserve’ signal active Top up pack
(unit remains operable even
without topping up, see
Ä
Chapter
8.1 ‘Changing the application tip’
on page 28 )
‘Product: Empty’
appears on display and red LED
flashes
Storage pack is emptyr
Top up product (see
Ä
Chapter
8.1 ‘Changing the application tip’
on page 28 )
Disconnected or
defective cable
Reconnect ‘Empty’ signal cable or
replace it
‘Alarm: Spray air’
appears on display and red LED
flashes
Connecting cable to
solenoid valve defective
Replace connecting cable
Solenoid valve defective Replace solenoid valve
‘Alarm: Control valve’
appears on display and red LED
flashes
Connecting cable to
solenoid valve defective
Replace connecting cable
Solenoid valve defective Replace solenoid valve
When the cause of the problem has been removed, press ‘ENTER’ to
acknowledge the fault.
When the cause of the problem has been removed the applicator is ready
to work again.
Troubleshooting
30 417101439 Rev. 2-09.2019