Ecolab 417102214, User Manual

Page: 83 / 182

417102214_EDPL_V60.docx 83 Rev. 1.12.11
9.5 Software version display
Fig. 9.7
The current software version of the pump appears in the
top right of the main menu display (
1 ).
Lower-case letters after the software number ( 2 ) describe
internal changes to the software which have no impact on
how the device is operated.
Fig. 9.8
When a dongle board is connected (see chapter 8 ”
Upgrading the EDPL V60 to EDPL V60
PLUS
”), the current
software version of this board appears to the right of the
software version of the pump (
3 ).
9.6 Initial startup / Delivery state
Fig. 9.9
Upon delivery, the pump is protected against gear oil
leakage by means of a seal on the oil fill aperture.
ATTENTION
Prior to startup:
Replace the sealing plug on the oil
fill aperture with the supplied
bleeder plug.
9.6.1 Basic setting / Display at operating level
The following settings appear on the display in delivery state after the pump is
switched on (ON/OFF switch to "I"):
Fig. 9.10
Operating mode: Internal
Metering frequency / rate in: Strokes/min (120 strokes / min)
Operating state: OFF (Start: press START / STOP button)
NOTE
In order to change the settings which are preconfigured in the factory, see the
corresponding menu options in chapter
10.4 "Configuration".
9.6.2 Basic setting / Configuration
The following factory settings are defined in the configuration:
Fig. 9.11
Configuration: Standard: see chapter:
Language: German 10.4.3
Unit: Litres 10.4.4
Max. output: 100% 10.4.5
Code: (-) not active 10.4.6
Auto start: (-) not active 10.4.7
Metering lock: (-) not active 10.4.8
Level contact: (

) empty = contact open 10.4.9
Alarm output: (

) alarm = relay on 10.4.10
Pulse memory: (-) not active 10.4.11
Oval gear meter: (-) not active 10.4.12
Metering controller: (-) not active 10.4.13
Metering monitor: (-) not active 10.4.14
Batch: (-) not active 10.4.15