2
Safety
2.1
General Safety
DANGER!
If you assume that safe operation is no longer possible the pump must be put
out of service immediately and be secured against unauthorized use.
This is the case if:
– is visibly damaged
– appears no longer functional
– prolonged storage under unfavorable circumstances has occurred
(carry out function check).
The following notes should be observed:
– Before any work on the electrical section, disconnect power and secure
against being switched on again .
– The safety provisions for handling chemicals must always be observed and,
if applicable, suitable protective clothing must be worn
– Notes in the product data sheet of the used dosing medium has allways to
be observed.
– The installation may only used with the specified supply and control voltage
in the technical data.
2.2
Proper use
NOTICE!
Only Ecolab products approved for this dosing system may be used.
No liability is accepted for the use of products other than those
approved!
WARNING!
roper use particularly includes the following points:
– Only liquid, validated chemicals may be metered.
– The temperature range, the permissible ambient temperature and the
maximum media temperature is permissible only as described in the
"Technical data".
– The operating voltage has to be produced only as described in the
"Technical data".
– The pump has been developed, designed and built for industrial and
commercial use. The unit is not intended for private use.
Any use which extends beyond or differs from the proper use is considered
improper use.
Proper use also includes compliance with all control and operating instructions prescribed
by the manufacturer, as well as with all maintenance and servicing conditions.
Safety
11
Rev. 5-06.2018
