OPERATION INSTRUCTION
Join the TUYA App
This product needs to be added to the TUYA APP intelligent system, which requires
the installation and registration to the TUYA App. There are two ways to connect to
your local Wi-Fi Network (Wi-Fi 2.4GHz Router is required).
The configuration processis as follows.
Smart Configuration mode:
1 - After the device is powered on, the LED flashes for 3 mes (initilisation) and then
automa cally requests to enter the network. If the network access fails, the LED will
flash rapidly, which indicates that the device has entered the smart configuration
mode.
2 - Aer step 1, open the Smart Life App, successively click button in the upper
right corner of the home page
→
Security & Sensors
→
Contact Sensor (Wi-Fi)
→
Confirm
indicator rapidly blinking
. Enter Wi-Fi password, click
Confirm
, wait for the networking
to succeed. If successful, the door-window detector LED will flash 10 times.
AP Configuration mode:
1 - If the Smart configuration mode fails to access the network, remove the battery
and power on again. After the product completes initialization, the LED will flash
slowly, indicates that the device has entered the AP configuration mode.
2 - After step 1, open the Smart Life App, successively click button in the upper
right corner of the home page
→
Security & Sensors
→
Contact Sensor (Wi-Fi)
→
Other Mode
(in the upper right corner)
→
AP Mode
→
Confirm indicator slowly blinks
→
and then enter
Wi-Fi password, click
Confirm
→
Connect your mobile phone to the device's hotspot
→
select SmartLife-xxx, then wait for the networking. When successful, the door-
window detector LED will flash 10 times.
After adding successfully, the open/close status of the door-window detector can
be displayed in the app in real time.
Sensor detection mode description
When the sensor is powered on, the red indicator light starts to flash for 3 times
and the sensor enters the preheating mode. After 16 seconds, the preheating is
completed and enters the distribution network mode. After the router is connected
successfully, the device enters the test mode. In the test mode, each time the sensor
detects that the door is open or closed, it will immediately enter the next detection
state. The test mode will last for 5 minutes. After 5 minutes, the sensor automatically
enters the power-saving mode. In the power-saving mode, each time the sensor
detects the door is open, it will wait 10 minutes to enter next detection state for
detecting door open/closed again. If the sensor is repeatedly triggered within 10
minutes, the sensor will not enter the next detecting state until 10 minutes later. If
there is no trigger during 10 minutes, the sensor will re-enter the detection state.
Note: If you need to enter the test mode again, remove the sensor battery, wait for
one minute, install it again to enter the test mode again.
Sensor detection mode description
Figure 1 Door frame and door not level.
Figure 2 Door frame is level.
1) Door open
2) Door Close
1
Mainframe
3
3M Glue
2 Magnet
3 3M Glue
2
Magnet
1
Mainframe
Slowly blink 3 times
Flashes rapidly twice per second
Flashes slowly once per 3 seconds
Flash 10 times rapidly
Flash once
lnitialization after power on.
Smart Configuration mode
AP Configuration mode
Connect the router successfully
Door open/close
Indicator
Function
