FCC STATEMENT:
This device complies with Part 15 ofthe FCC
Rules.Operation issubjecttothe
following two conditions:
1)This device may not cause
harmful interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING: Changes ormodifications not
expressly approved by the party responsible
for compliancecouldvoidthe
user’sauthorityto operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device,pursuantto Part15 of the FCC
Rules.These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
Thisequipmentgenerates,uses,andcan
radiateradiofrequencyenergy and,ifnot installed
and used in accordancewith the instructions,
may cause harmful interference
toradiocommunications.However,thereis no
guaranteethatinterferencewillnotoccur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined
byturning the equipment offand on, the user is
encouragedtotryto correctthe interferenceby
oneormoreofthe followingmeasures:reorient or
relocate the receiving antenna, increase
the separation between the equipment and
receiver,connectthe equipmentintoan outlet on
a circuit differentfrom that to which the
2
PowerOn,Battery,&
LED Status Indicators
Oncefullycharged,pressthe
Standby Power Button
on
the top ofyourEcoDrift. You
will see the greenLED light &
you will hear, “Power on”
when powering on.
IMPORTANT:Makesurethatthe
MainPowerSwitch,located in the
back compartmentunderthe cap,is
set in the ON position. If the
switch is in the OFF position,
yourEcoDriftwill not be able to
turn on using the Standby
Power Button.
TheLEDbatterylevelindicators
arelocated on the top ofthe unit.
Each bar represents 25% of a
charge,with4fullLEDsindicating
a full charge.
Audioplaybacktimeover
Bluetoothconnectionis
approximately15 hours at
75% volume.
