© 2020
-
03 EcoAir 4 All rights reserved
QUICK START UP
STEP 3
-
ON/OFF
TO
OPERATE
DD3
CLASSIC
MK2
•
Always place the dehumidifier in an
upright position on an even level
surface.
•
Plug the dehumidifier into the mains
socket, the standby mode indicator
will remain on whilst the dehumidifier
is plugged in to the mains.
•
Press the ON/OFF button to operate
the dehumidifier.
STEP 1
-
WHERE TO POSITION YOUR
DEHUMIDIFIER?
Ensure the dehumidifier is a safe distance away from
a wall or furniture, away from direct sunlight.
TIP:
Position the dehumidifier in the dampest room
or somewhere central like a landing or a hallway. As
long as the internal doors are open the excess mois-
ture from all of the rooms in the house will migrate
naturally towards the dehumidifier and be processed.
STEP 2
-
CAUTION
-
AVOID USING IN
•
Areas where ambient temperature falls below 1°C.
•
Small confined area i.e. broom cupboard, boiler
room, unventilated rooms etc.
•
Close proximity to a heat source such as heater,
tumble dryer, cooker.
•
Dusty or building sites or an industrial
environment where particles can clog up the filter
or internal components. This will cause the dehu-
midifier to malfunction, voiding your guarantee.
Min 40 cm
Min 40 cm
Min 40 cm
STEP 4
-
HUMIDITY SETTING
•
Press the humidity setting button to set the hu-
midity in the following loops with 1 or 2 LED, 5%
stage display:
Note : The display will go back to the ambient humidity
level in 3 seconds, after setting the desired humidity level.
•
When the humidity setting is higher than the in-
door humidity, the humidity setting LED flashes
and the machine will enter energy saving mode,
HEATER turns OFF and the FAN stops after 2
minutes for cooling operation.
•
After 30 minutes pause, the fan will start and run
for 5 minutes while the unit checks the indoor hu-
midity. If the humidity is higher than 5% of the set
value, the machine will restart.
•
If not, it stops for another 30 minutes. During the
pause, buttons are still settable.
Min 40 cm