8
7
OPERATION
OPERATION
Connect hand-held unit
Connect cable to base making sure that the pins line
up, then screw to lock in position. Do not start the
machine until strapped on to the operators back.
Operator to place on thier back and adjust straps
accordingly ( please see page 8 ) Do not start the
machine until strapped on the operators back
Important information
ALWAYS REMOVE THE HANDHELD CONTROLLER
WHEN THE MACHINE IS NOT IN USE
Using the hand held remote
to commence operation
•
To commence operation make sure that the
fluid controller is set to 0.
•
Turn the on/off button to number 1 setting
which turns on the battery, which starts the
pump, the fan and the solenoid.
•
After 5 seconds press the red button which
ignites the burner in the lance. You will hear this
ignite.
•
Turn the fluid controll dial to setting 10 until you
see detergent appear from the lance brush.
•
Then turn the fluid control dial to setting 0 for 1
minute while the boiler heats up.
•
Next turn the fluid contoll dial to the required
setting ( for gum removal set between 2-3 a
small adjustment may be required depending
on the surface or for a different use increase
accordingly)
•
Note: The fluid indicator will light up when the
solution is empty in the backpack.
1. BATTERY CHARGE INDICATOR
2. ON OFF BUTTON
3. RED IGNITION BUTTON
4. YELLOW FLUID CONTROL DIAL
5. FLUID LEVEL INDICATOR LIGHT
1.
2.
3.
4.
5.
Adjusting the Machine
Unclip waist and chest straps. Loosen shoulder straps
and hip belt.
Put on unit by placing arms through shoulder straps
and secure and tighten the hip belt.
NOTE: For the most comfort, adjust unit so that the
hip belt covers the front hipbones and the bowed-
out portion of the back padding rests on the small
of the back.
Tighten the shoulder straps to the point where
the unit’s weight just starts to pull down on the
shoulders. Ideally most of the unit’s weight will
remain on the waist.
Adjust the chest strap position to be high on the
chest and tighten till comfortable.
Cleaning Gum
Once the machine has heated up, place the brush on
the piece of flattened gum and wait 5-10 seconds.
Agitate the flattened gum with the brush using
circular motions until you see gum disintegrate. Do
not scrub or apply pressure. The weight of the lance
with agitation is all that is required.
Remove the brush from the gum and use a broom to
sweep across the area. Determine if all the gum has
been removed or if more cleaning is required.
If further cleaning is required, repeat the cleaning
steps until gum is completely removed.
NOTE: Always complete a test patch on surfaces to
make sure no damage occurs to the flooring
or surface.